RC1xx LED Lighting Controllers - User Manual
—
6
—
2.1
Heat
Ensure the RC1xx is mounted correctly (see Section 5, “Mounting the
RC1xx”), and that you do not exceed any of the ratings for the unit (see
Section 11.1,
).
At its maximum ratings, the RC1xx’s enclosure can exceed 65°C which is
sufficient to cause a burn if touched. Place in a position where personnel
cannot accidentally touch it and ensure there is a free flow of air around
the unit.
2.2
Electrical
The RC1xx produces high energy pulses. Take care to connect the outputs
correctly and protect the output wiring and load from any short-circuits.
When switched off, energy remains stored in the RC1xx for about 15
seconds.
The RC1xx does not have complete tracking isolation of input and output.
Transients caused by inductive loads must be suppressed externally to the
RC1xx.
Warning:
This is a Class A product. Its use in residential areas may
cause radio interference, and such use should be avoided unless special
measures are taken by the user to restrict emissions to a level that allows
the reception of broadcast transmissions.
2.3
General
The RC1xx must not be used in an application where its failure could be a
danger to personal health or damage to other equipment.
If the equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
2.4
Installation guidance (disclaimer)
This information is for guidance only. Installers must perform their own
risk assessment specific to each installation. While Gardasoft Vision Ltd
has taken every care in the preparation of this advice, Gardasoft Vision Ltd
accepts no liability for damages of any kind except those required by law.
Deliberate acts of endangerment and vandalism are not covered by this
document and must be considered by the installer.
3
Sicherheitsvorkehrungen
Bitte lesen Sie dieses Dokument, bevor Sie die RC1xx verwenden. Beachten
Sie immer die folgenden Sicherheitshinweise. Bei Fragen wenden Sie sich
an Gardasoft Vision Ltd. Die folgenden Symbole werden in dieser Anleitung
verwendet:
