GarageAce S3, Руководство пользователя

Страница: 15 / 16

11
9. Trouble shooting
The product appearance and functions will be changed by development without further
notice. This manual is for reference only, the actual item is the standard.
Trouble Reason Solution
The motor doesn’t work and
has no display on LED
●Opener is not powered on
●Fuse on main control board is
damaged
●Switch on the power,
inspect “ POWER” socket
●Change fuse to the same
type fuse.
The motor doesn’t work and
the LED displays 1. ●Travel adjustment error
●Re-adjust limit position
The door stops before it is fully
up on opening cycle; LED
displays 2. or 3.
●The closing resistance is greater
than that system set load which
activates the barrier protection
system ●Inspect and adjust the door
balance system
Door auto-reverses before
reaching the ground on
closing; LED displays 3.
●The closing resistance is greater
than that system set load
activates the barrier protection
system
●Inspect and adjust the door
balance system
●increase door closing load
The door won’t run in the
closing door direction, LED
display 4.
● The photo beam is shielded;
● System started to use photo
beam system, but it hasn’t been
connected.
● Remove the barrier in the
beam road.
● Prohibit using photo beam
or connect the photo beam
Motor stops after a moment
of running, LED display 7. ● speed sensor wire is loosed
● speed sensor is broken ● reconnect the wires
● change speed sensor
Motor cannot run, LED display
8
● DC motor wire is loosed
● DC motor is broken
● control board is broken ● reconnect the wires
● change DC motor
● change control board
Push button can operate
normally, but remote control
won’t ● The transmitter has not learned
● It has no battery in the
transmitter
● Learn transmitter according
to the manual
● Change the battery of
transmitter
The remote working distance
is less, the brightness of
indicator lamp is lower
●The battery power is not enough ● Change the battery
Remote operates normally,
but the push button work
respond
● Push button loose or broken
circuit
● Inspect push button wiring