GarageAce S3, Руководство пользователя

Страница: 11 / 16

7
4.3.4. Open force setting
Press the “P” button until LED shows as Fig20. Pressing “+” and “-” will
adjust the opening load force by adjusting the value from 0 to 9. After
adjusting, press “P” to confirm. If you needn’t change the value, just
press “P” and the system will automatically enter into next step.
Value meaning: 0 ~ 9 - the bigger the value, the bigger the opening door
force is and the lower the sensitivity of protection against any obstruction.
4.3.5. Close force setting
Press the “P” button until LED shows as Fig21. Pressing “+” and “-” will
adjust the closing load force by adjusting the value from 0 to 9. After
adjusting, press “P” to confirm. If you needn’t change the value, just
press “P” and the system will automatically enter into next step.
Value meaning: 0 ~ 9 - the bigger the value is, the bigger the closing door
force is and the lower the sensitivity of protection against any obstruction.
4.3.6. Photo beam
Press the “P” button until LED shows as Fig22. Pressing “+” and “-”
will adjust photo beam by adjusting the value from 0 to 2. After the adjustment,
press “P” to confirm. If you needn’t change the value, just press “P” and
the system will automatically enter into next step.
Value meaning: 0 - No photo beam; 1 - valid while closing; 2 - valid
while both closing and opening.
4.3.7. Auto close
Press the “P” button until LED shows as Fig23. Pressing “+” and “-” will
adjust the auto-closing time by adjusting the value from 0 to 9. After the
adjustment, just press “P” to confirm. If you needn’t change the value, just
press “P” and the system will automatically withdraw from the settings.
Value meaning: 0 - prohibit the auto close function; 1 ~ 9 - Auto close delay time 1min
～
9min.
4.3.8. Transmitter learning and deletion
4.3.8.1. Transmitter learning
Under opener standby mode, press “-” until the LED dot lights up
then release the button. Press the same button on transmitter more than
twice. The dot will blink quickly and turn off in 2 seconds. This means the
learning is successful. If it is not successful, the dot will be off without blinking
in 2 seconds. Please refer to Fig. 24. The wireless wall switch is also programmed the same as
the transmitters. Repeating this process can learn more transmitters. Any button can be
programmed on the remote for your door or if you have 2-4 doors you can program the other
buttons for these doors.
4.3.8.2. Transmitter deletion
Under opener standby condition, press “-” for around 6 seconds until LED dot
lights up and then goes off, then release the button. All the transmitters are deleted.
Notice: After this process, all transmitters need to learn again.
Figure 20
Figure 21
Figure 23
Figure 24
Figure 22