Ganz ZN-L7210PHA, Инструкция по эксплуатации

Страница: 22 / 31

22 ENG-
Relay setting
Ù
Relay configuration
The switching conditions for the relay output can be configured. The function of an open
switching relay (normally closed contact) or a closed switching relay (normally open contact)
can be specified. It is also possible to specify whether the output should operate as a bistable
or as a monostable. In bistable operation, the activated state of the relay remains as switched.
In monostable operation, the time can be selected after which the relay is to revert to its
steady state. Various events can be selected to automatically activate the output. In this way,
for example, it is possible to switch on a floodlight when a motion alarm has been detected
and to switch the light off again at the end of the alarm.
Please note that changing the default configuration the relay will work as set when the camera
is powered on but as indicated in the previous session when powered off.
Idle state:
select
Open
if the relay is to operate as a normally open contact or
Closed
if it is
to operate as a normally closed contact.
Operating mode:
select the operating mode for the relay. If, for example, a lamp is switched
on by an alarm and is to remain on when the alarm has ended, select
Bistable
.
If an acoustic signal activated by an alarm is to remain on for a period of, for
example, 10 seconds, select
10 s
.
Relay follows:
select a particular event by which the relay is to be activated as required.
The following events can activate the relay:
¾
Off
: No relay triggering by events
¾
Connection
: Triggering if any connection is established
¾
Video alarm
: Triggering caused by loss of the video signal
¾
Motion alarm
: Triggering by the motion alarm
¾
Local input
: Triggering caused by an external alarm sensor
¾
Remote input
: Triggering by a switching contact from a remote location.
Relay name:
the relay can be assigned a name from here. The name will be shown on
the live page, dependent upon configuration.
Trigger relay:
click on the button
Relay
to manually switch the relay (e.g. for test
purposes or to operate a door opener).