11
ENG-
Commissioning with terminal program
You can connect a data terminal to the camera for putting it into operation and for local control.
The data terminal consists of a computer with a terminal program. For the connection use a
serial NULL-MODEM cable.
The needed configuration port is:
¾
19200 Bit/s
¾
8 data bits
¾
No parity check
¾
1 stop bit
¾
No protocol
After the connection has been made and
service
has been entered as Login and Password,
the camera automatically transmits the Help page.
¾
If necessary, switch off the local echo so that input values are not repeated.
¾
Enter only one command at a time and do not terminate this input by pressing the
[Enter] key.
¾
After entering a value, check the entered characters and only then press the [Enter] key
to transmit the values to the camera.
Assigning the IP address
¾
Start a terminal program.
¾
Enter
i
the existing IP address is displayed (default: 192.168.0.1)
¾
Enter the new IP address and press the [Enter] key. The new IP address is displayed.
Other commands
?
Displays the Help page
i
Displays and modifies the IP address
s
Displays and modifies the Subnet Mask
g
Displays and modifies the Gateway
a
Displays and modifies the alarm IP address
c
Connect to the alarm IP address
d
Stop
connections
m
Displays the MAC address
v
Displays the firmware and hardware version
b
Displays the current data rate