EG-7
Connecting the cables
Connect the power and video cables.
Connect the video cable from the monitor and the coaxial video cable attached to
the camera body.
Connect the power cable.
●
When using 12V DC, connect the positive (+) terminal to the terminal marked
"+12VDC".
12V DC connection
24V AC connection
Attention
●
Be sure to check that the cables are connected correctly before turning the
power on.
●
Turning on the power when the cables are connected with incorrect polarity
may damage the camera.
Setting the mode setting switch
Attention
●
Do not alter the position of the mode setting switch marked “FIX” from its
factory default setting.
1
FIX
Do not change the switch position from the factory setting.
2
Flickerless (FL)
ON
Shutter speed to be fixed at 1/100.
OFF
Normal position
3
Backlight
compensation
(BLC)
ON
Set to this position when a strong light is in the back
ground.
OFF
Normal position
4 Synchronization (Sync) INT.
Internal synchronization mode
L.L.
Line lock mode (24V AC, 60Hz only)
Attention
●
Setting the flickerless function to "ON" will give a darker picture than when
set to "OFF" in low light conditions.
Factory default switch settings
Connect the video cable from the
monitor here.
(US)ZC-D5000NTSC_0830.indd 7
2006/08/30 15:18:21
