43
SYSTEM : SYSTEM MANAGEMENT
F/W version
: Shows the current firmware version of the DVR.
H/W version
: Shows the hardware version of the DVR.
VIDEO SIGNAL TYPE
: The DVR will automatically switch between NTSC and PAL, depending on the
type of input signal from Channel 1 at power on. (Switching will re-format the HDD.)
DISK CAPACITY
: The first value shows the amount of hard drive capacity used by recorded video; the
second value shows the total hard drive capacity installed on the DVR system.
IP ADDRESS
: Shows either the manual IP address entered in NETWORK setup or the IP address
assigned by a DHCP server if enabled.
MAC ADDRESS
: Shows the MAC (Media Access Control) address of the DVR. This is a unique hardware
address – no two network devices can have the same MAC address.
SYSTEM NAME
: A system name of up to 10 characters can be defined. It is used so that notification
e-mails can be identified more easily between multiple DVR systems.
PASSWORD
: This setting toggles the system password prompt ON or OFF.
F/W UPDATE
: Firmware updates may be released periodically to enhance system performance and
add extra features. The operator can upgrade the firmware using a USB Memory Stick.
FACTORY DEFAULT
: If settings have been changed which cause erratic behavior in the DVR system, the
factory default settings can be restored.
SYSTEM DATA
: System settings can be saved to a USB Memory Stick. The settings can be reloaded
in case of accidental factory reset or can be transferred to another DVR if multiple
units need to be installed with the same settings. All information is saved except for the
network settings and the system name.
SYSTEM SETUP
SYSTEM SETUP
Click the
SYSTEM MANAGEMENT
menu.
You may click on the PRESS buttons to perform a
Firmware Upgrade or to set unit to Factory Default.
You may click SAVE to save the current system
configuration to a USB Memory Stick, or click LOAD
to load a saved configuration from USB.
