Storm Form and Storm Form DMX User Guide
Version 1.1 – 2/25/2021
Safety and Operation notes:
Please carefully review the following safety notes regarding the Storm Form micro gobo projector. These
notes are important for safe installation and usage of the product.
Do not look directly at the light source while the fixture is powered on.
Inspect all power cables for damage or crimped cable before use.
Make sure that your circuit is properly grounded and all electrical safety precautions have been
taken to prevent electric shock.
Be aware that the fixture will become HOT to the touch when it is left on.
Allow several minutes for the light to cool before touching it after extended periods of on time.
Ensure that there are no flammable materials close to or in contact with the light fixture.
Never touch the lenses within the fixtures. If the lenses must be cleaned, use a microfiber cloth
and glasses cleaning solution.
Make sure that the locking cable connectors are fully tightened when the product is installed.
Check the voltage of the power line before connecting the fixture to ensure that it is within the
required range for the fixture.
In the event of a serious operating problem, cut power to the fixture and cease operation
immediately.
For technical support, please contact
or call 1-855-GANTOM1 (1-855-
426-8661).
MOUNTING INSTRUCTIONS
The Storm Form micro gobo projector comes with an aluminum mounting yoke pre-installed. It is meant
to be used with ¼” size hardware, but please note that mounting hardware is not included with the
fixture. The yoke has a hole and a curved slot. Install a screw in the center hole first, then loosely screw
down a second screw through the curved slot. Rotate the fixture to the appropriate angle and then
finally tighten down both screws all the way to lock the fixture in place.
