IDL 101
FUNCTIONAL DESCRIPTION
42
HB_IDL101_E_V222.doc
Gantner Instruments Test & Measurement GmbH
5.2. Analog Output Channel
The Analog Output Channel has the function of a voltage output. The limit values for the voltage range can be set
between 0 and 10 V by means of the
Configuration Software ICP 100.
Via the analog output (AOut +, AGND) at the
Datalogger IDL 101 actual measuring values or sensor variables can be
output depending on the configuration. Thus for example it is possible to assign the value of a Setpoint Channel or the
result of an Arithmetic Channel to the Analog Output Channel and to output them as analog set values.
Analog Signal Output:
Figure 6.8 Analog Signal Output
With the analog signal output the value, which is assigned to the Analog Output Channel will be output as a voltage
value. Thus the lowest defined value corresponds to the lower limit value of the measuring range (> 0 V) and the
highest defined value corresponds to the upper limit value of the measuring range (max. 10 V). The values between
these two points will be calculated by the
Datalogger IDL 101 based on a linear characteristic.
The actualizing rate of the output value decreases with an increasing number of defined variables where as the swing-in
rate of the output will be 1 s.
RUN
ERR
A
O
u
t
+
A
GN
D
Connection Scheme
Circuit
AOut +
A
GND
AOut +
A
GND
M
M
