Gantner GAT ECO.Side Lock 7000 BA, Установка, наладка и эксплуатация

Страница: 34 / 64

GAT ECO.Side Lock 7000 BA / NW BA
Commissioning
34
HB_GAT-GAT-ECOSide-Lock7000-BA--EN_14
www.gantner.com
Figure 4.1 - GAT ECO.Side Lock 7000 BA battery compartment
► Ensure that the battery polarity is the same as shown in Figure 4.1.
► Press the battery down into the compartment until it locks into place.
► Reinstall the battery cover over the battery compartment and push down until the battery cover is level with the
surrounding GAT ECO.Side Lock 7000 BA housing.
o
When installing the battery in the GAT ECO.Side Lock 7000 BA for the first time, the process is now
complete.
o
When the lock has already been used and the battery is being replaced, the lock must be activated
using the B
attery data carrier (see “4.2.3 Replacing the Battery).
After inserting the battery, the GAT ECO.Side Lock 7000 BA is in start-up mode for approximately 2 minutes.
During this time, the LED is solid green with a red flash every 4 seconds. The LED switches off and a sound
signal is activated when start-up mode ends.
Replacing the Battery
The battery of the GAT ECO.Side Lock 7000 BA must be replaced when the LED flashes red 5 times and 5 beeps
are emitted during a locking attempt. In this state, the GAT ECO.Side Lock 7000 BA can no longer be locked until
the battery is replaced.
Always dispose of used batteries in an environmentally friendly way, e.g., at an electronic waste
recycling facility.