2
4
5
ISSUED 06-23-20
PATENT PENDING
PAGE 1 OF 3
INSTALLATION INSTRUCTIONS
:
1. Install mortise lock body (item 1) using (2) 12-24 combo screws (item 9). Mount mortise lock face plate (item 8) using
(2) 8-32 FHMS (item 10).
2. Determine if handle & base assembly (item 4) is to be mounted vertical or horizontal. Place handle assembly on
appropriate side of door and rotate cam as per detail "A", shown above. In detail "B", insert (2) 10-32 sex bolt (item 11)
that match the holes on the door face through the handle & base assembly (item 4) and mortise lock body (item 1) into
the exit only plate and attach with (2) 10-32 screw (item 7).
3. Test lock for proper operation. If latch bolt does not extend or retract freely because of any type of binding, loosen
mounting screws to adjust alignment of trim handle & base assembly (item 4) and re-tighten screws one at a time while
checking latch bolt movement.
4. To prevent the handle & base assembly (item 4) from possible twisting, which in turn can cause binding, determine
which staking screw hole will be used. (the staking screw installs on the staking screw hole location opposite the
direction the handle is mounted). Install (1) #12 PHSMS staking screw (item 6).
5. Place cover (item 2) over handle and fasten each side with (2) 8-32 oval head screws (item 5).
DETAIL "A"
NOTE:
BEFORE MOUNTING BASE ASSEMBLY,
CAM MUST BE ROTATED AS PER
DRAWING SHOWN IN DETAIL "A".
(MUST POINT
HANDLE
HORIZONTAL
DOWN
HANDLE
UP
HANDLE
*
*
HINGE SIDE)
*
*
1
STAKING
SCREW HOLE
6
LR6600 - EXIT ONLY OPTION
INSTALLATION FOR MORTISE LOCK TRIM
"PS" OPTION - LR6600 TRIM ON PUSH SIDE & EXIT ONLY PLATE ON PULL SIDE
"PL" OPTION - LR6600 TRIM ON PULL SIDE & EXIT ONLY PLATE ON PUSH SIDE
LR6600 - EXIT ONLY
"PS" or "PL" OPTION
LR6600 - EXIT ONLY PS OR PL OPTION-1-02.DWG
BASE ASSEMBLY
6-32 X 3/8" SHCS
7 (10-32 X 1/2" FHMS)
HANDLE ASSEMBLY
DETAIL "B"
3
5
6-32 X 3/8" SHCS
STOP PIN
NOTES
1. TRIM CAN BE MOUNTED UP, DOWN OR HORIZONTALLY.
2. USE ABH MORTISE LOCK DOOR PREP TEMPLATE.
3. MORTISE LOCK CYLINDER NOT PROVIDED.
10
9
9
8
PARTS LIST
DESCRIPTION
QTY
ITEM
1
MORTISE LOCK BODY
1
2
COVER
1
3
1
4
1
5
8-32 X 3/8" OVAL HEAD MS
2
6
1
EXIT ONLY PLATE ASSEMBLY
#12 X 1/2" PHSMS STAKING SCREW
HANDLE & BASE ASSEMBLY
7
10-32 X 1/2" FHMS
2
8
9
10
1
2
2
FACE-PLATE, MORTISE LOCK
12-24 X 3/4" FH COMBO SCREW
8-32 X 1/4" FHMS
(SEE DETAIL "B"
FOR EXPLODED
VIEW)
11
2
10-32 X 1-1/2" SEX BOLT
11
c
