Gantner GAT Access 6100 Series, Установка, наладка и эксплуатация

Страница: 59 / 99

GAT Access 6100 Terminal Series
Commissioning & Configuration
www.gantner.com
HB_GAT-ACCESS6100--EN_14
59
5.4.4 Display Texts
The texts, which are shown on the display of a GAT Access 6100, can be edited in GAT Config Manager. In the
project window of a GAT Access 6100 (see Figure 5.19), click on the "Display Texts" tab.
Figure 5.21 - Display text configuration
In the left column, the type of text is indicated (information see below) and in the right column, the text can be entered.
Each separate line of text is also shown on a separate line on the display. The maximum length of one text line is 21
characters. If a line of text does not fit on the display of the GAT Access 6100 (using the standard font size), the GAT
Access 6100 automatically uses a smaller font size to display the entire text line.
The access terminals can only show signs of windows code page 1252 (Western European), 1251 (Cyrillic) and 1257
(Baltic). All other signs will be shown as "*" on the display.
Definition of the texts
- Idle:
This text is shown during normal online operation mode to instruct the user to hold their
data carrier next to the reading field.
- PushButton: Is shown when a key must be pressed by the user (Second Ident, answer from
Card_Ident status 240 - 255).
- ConfigMode: Is shown when the host computer is the communication master, e.g., when the
configuration is being loaded from/to the GAT Access 6100.
- ExternalLocked: Is shown when an optocoupler input is defined as "
Ext_Locking“ (external locking), the
optocoupler is active, and a user data carrier is read by the terminal.
- CardAgain:
Is shown when “Locker Check-In” is activated and a user removes their data carrier
too soon from the reading field so that the locker data could not be deleted from the
data carrier.