G&L MMC-A2, Руководство по оборудованию

Страница: 32 / 192

Installation, Operation, & Maintenance
24 MMC Hardware Manual G & L Motion Control Inc.
3.7 Basic Setup and Maintenance Procedures
Table 3-2 below summarizes how to proceed when performing certain
maintenance and/or setup functions.
Table 3-2: Maintenance Procedure Summary
3.8 System Status Lights
Three lights on the front of the Control (Scan, Power, and Diagnostic labeled
“S”, “P”, and “D”), shown in
Figure 3-8 , provide diagnostic and operational
In order to:
Turn off the entire application. Turn off main disconnect (which should
also turn off all external power supplies to
the application); unplug the DC power to
the MMC.
Wire the I/O to the application. Turn off main disconnect (which should
also turn off all external power supplies to
the application); unplug the DC power to
the MMC.
Change the battery. Turn off main disconnect (which should
also turn off all external power supplies to
the application); unplug the DC power to
the MMC.
Connect/disconnect the MMC with the
computer workstation through the
PiCPro port. Turn off main disconnect (which should
also turn off all external power supplies to
the application); unplug the DC power to
the MMC.
Connect/disconnect the MMC with an
operator interface through the User port. Turn off main disconnect (which should
also turn off all external power supplies to
the application); unplug the DC power to
the MMC.
Download an application program into
the memory. Make sure power is on (check the P light).
Stop the scan. From the workstation - use the Stop Scan
commands in the PiCPro software.