G&D DVIMUX2-DL-USB, Инструкция по установке и эксплуатации

Страница: 67 / 100

Switching
G&D DVIMUX2-DL-USB · 14
English
Enabling the »Switch« mode
If necessary, change the standard mode of the RS232 port (see page 38) to this mode
if you want to switch channels via serial device immediately after starting the KVM
switch.
To switch from Monitoring mode to Switch mode, enter the command » ! « during oper-
ation.
Switching commands
The following commands are provided for switching the channel:
Messages
The KVM switch confirms the successful execution of a command and otherwise
sends a meassage.
IMPORTANT: The RS232 port can be used to switch the active channel via serial
device or to get monitoring information (see page 16).
Switching of channels via the serial device is possible only if the
Switch mode is active!
Command Channel
1! 1
2! 2
<! switch to previous channel
>! switch to next channel
ADVICE: Use the » ?! « command to show the currently accessing channel.
NOTE:
The serial device carries out the command directly after it is sent.
A message (see below) informs the serial device concerning the success or failure
of the switching of channels.
Message Meaning
In [x] All switching to channel [x] successful
E01 invalid channel number (out of range)
E06 channel switching failed
E10 invalid command
E13 invalid value (out of range)
RS232 mode enabled switch mode (RS232) enabled