Gamma 7900 Els, Руководство пользователя

Страница: 5 / 28

5
ASSEMBLY INSTRUCTIONS
Floor Stand Assembly
With the Spring Pin engaged and the Knob
Key positioned in the deep slot, loosen that
Lock Knob and lift the upper column. As the
upper column is lifted out of the lower column,
the Spring Pin will ratchet as it engages and
disengages the teeth of the gear track.
To lower the upper column, loosen the Lock
Knob and while holding and supporting the
upper column, pull out the Spring Pin, set the
Knob Key into the shallow slot and lower the
upper column.
Floor Stand Assembly
The fl oor stand features a ratcheting
Self-Locking system that incorporates a
Spring Pin on the lower column to engage
a gear track in the upper column. To set
the Spring Pin to engage or disengage
the Gear Track, pull the Spring Pin Knob
out out from the housing and rotate it 90
degrees to position the Knob Key into
the deep or shallow slot of the Spring Pin
Housing. When the Knob Key is positioned
in the deep slot, the Spring Pin will be in
the Self-Locking position and will engage
the Gear Track. When the Knob Key is set
in the shallow slot, the Spring Pin will be retacted and not engage the Gear Track.
Spring
Pin
Gear
Track
Spring Pin
Engaged Lock Knob
Loosened
Helpful Tip: When setting the height, it is best to start from the lowest position and gradu-
ally raise the height until the Slef-Locking Spring Pin is engaged in the Gear Track at the
desired height.
Floor Stand Leg Assembly
The stringing machine uses a four leg fl oor
stand design. The legs must be assembled
to the Lower Column before use. Remove
all parts from the shipping carton to confi rm
that contents match the parts list.
Align the holes in the Leg Flange with the
matching holes in the Lower Column. Se-
cure the leg with one M8x30 fl at head screw
through the upper hole, and one M8x35
socket head cap screw through the bottom
hole. Repeat this procedure for the three
remaining legs.