MPCe/LPCe Users Manual
6
Specifications
Parameter
Specification
Operating temperature
0 to 40°C
Operating humidity
0 to 80% RH (non-condensing)
Storage temperature
-20 to 70°C
Dimensions
WxHxD: 483 mm (19") x 133mm (5.25") x 476 mm (18.75")
Input power
Requirements
115 VAC, 210-230 VAC configurable
100 mA (5 watts min, 325 watts max)
500 mA (6 watts min, 1056 watts max)
Serial interface:
Baud
Rate
number of start bits
number of stop bits
parity
number of data bits
9600
1
1
none
8
Set points (8):
Type
Set points 1 - 4 are relay; Set points 5 - 8 are TTL
Electrical
characteristics
Relay: 500 mA, 28V each, maximum
TTL:
15 mA each, maximum
Response
time
Parameters are measured at least every 320 milliseconds.
Assuming a set point decision is handled right after measurement is
made, response time is 320 milliseconds. Assuming a set point decision
is made on the next time through the standard loop response time is 640
milliseconds. Relays take a few milliseconds to operate, so this increases
response time slightly.
Line frequency
48 to 62 Hz. No adjustment necessary
High voltage output:
Short
circuit
+7000 VDC output standard; ±5600 and -7000 VDC selectable
Medium HV module:
200W, 100 mA
Large HV module:
1000W, 500 mA (MPCe only)
Polarity
Positive or negative (factory configurable)
Analog outputs:
0 to 10V
Voltage
Current
Operating Load
1V = 1000V
progammable
1V = 20mA or 20µA on 100mA HV modules
Lowest resistance = 2k
Ω
.
Pump size
Programmable from front panel or serial commands
