Gamewell IdentiFlex 610, Руководство по установке и эксплуатации

Страница: 36 / 158

IF 610 Installation and Operation Manual Issue 3, 10/04/00
Firmware Ver. 7
26
Installation
Diagram Refer to D-W1175, Wiring, IF 610 System; and drawing C-M818 Assembly of IF
610 Cabinet for installation and cable connections.
Specifications
Input Voltage 120 VAC 50/60 Hz 3 amps Max.
220/240 VAC 50/60 Hz. 2 Amps Max.
Power Fail / Brownout Transfer Per UL 864
Operating Temperature 0 to +49 degrees C
Humidity 85% non-condensing
Interconnects
24 VAC1
24 VAC2 (2) secondary transformer connection
BATT+
BATT- (2) connections to Battery
J1 connector Interconnects to J3 from the Front Panel Display
Ass’y
J2 connector Interconnects to P1 on the analog addressable
module
J3 connector Interconnects to SBX1 on the CPU card
Operators Display The Operators Display (OD) is the main interface to system. The display
provides the user with all necessary switches, keys and annunciation points to
maintain and monitor the system. Alarm, supervisory and trouble conditions are
indicated by dedicated LED's and the internal sounder. The system's operating
status is shown on the alphanumeric display. LED annunciation is also provided
for AC power, PreAlarm, and Bypass. The numeric keypad provides user access
for programming and password entry.
The alphanumeric display contains a 4 x 40 character backlit display. To regulate
the contrast of the alphanumeric LCD display, adjust the potentiometer R45
located (solder side of the display board - upper left hand corner) - see (Assembly
of IF 610 drawing C-M818-1). The card location identification number is " 0 "
(see above Table I-1).
Installation
Diagram 1. Refer to (Assembly of IF 610 drawing C-M818) The ribbon cable from J3 on
the Operator Display interconnects to the bus driver module (J1 connector).
2. Refer to (Assembly of IF 610 drawing C-M818) The ribbon cable from J3 on
the bus driver module interconnects to the CPU Card (ISBX1 connector).
3. Refer to (Assembly of IF 610 drawing C-M818) The ribbon cable from J2 on
the bus driver module interconnects to the Analog Card (P1 connector)
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com