Possible operating failures and method of repair
In case of any possible failure, use the information found in the table for repair:
Failure
Cause
Method of repair
The
engine
cannot be started.
There is no petrol in the fuel tank.
Fill the fuel tank up with clean fresh, lead-free petrol
.
The petrol is old.
Drain the old petrol from the fuel tank and fill it with clean
fresh, lead-free petrol.
The engine is cold. The control of the
carburettor air valve is in
“Fully open” position.
Put the air valve control in
“Fully closed” position.
The fuel cock lever is in
“Closed” position.
Put the fuel cock lever in the
“Open” position.
The butterfly valve control is in “turtle”
position
.
Set the butterfly valve control in
“rabbit” position
.
The cap of the high-voltage cable is not
attached on the spark plug.
Fasten the cap of the high-voltage cable on the spark
plug.
The spark plug has become contaminated
or failed; the free distance between the
electrodes is not properly adjusted.
Clean and replace the spark plug if necessary. Check the
free distance between the electrodes.
The
engine
does
not
smoothly
operate.
The air valve control is set in the wrong
position.
Set the air valve control in
(”Fully open”) position if the
engine has already been operating for 2-5 minutes (has
warmed up) or in
«fully closed » position, if it has just
been started.
There is an improper contact between the
spark plug and cap of the high-voltage
cable.
Attach thoroughly the cap of the high-voltage cable onto
the spark plug.
Old petrol. There is water and dirt in the fuel
system.
Drain the old petrol from the fuel tank and fill it up with
clean, fresh, lead-free petrol.
Contaminated air filter.
Clean or replace the air filter.
A Blades do
not rotate
Blades are blocked by stones or larger
soil pieces.
Stop the engine and remove cap of the high-voltage
cable from the spark plug. Clean the blades.
The V-belt has worn out or torn.
Contact a repair shop for the replacement of the V-belt.
The clutch cable is wrongly adjusted.
Adjust the clutch cable.
High level of
vibration
Fixation of blades has loosened or blades
have got damaged.
Stop the engine immediately and remove the cap of the
high-voltage cable from the spark plug. Replace failed
components.
Fixing screws have come loose.
Stop the engine immediately and remove the cap of the
high-voltage cable from the spark plug. Tighten or
replace the bolts.
ATTENTION:
FOR THE CLEARING OF FAULTS NOT TREATED ABOVE, CONTACT THE AUTHORISED
SERVICE REPAIR SHOP
.
The manufacturer reserves the right to modify the cultivator structure without previous notification for the improvement of
consumer characteristics.
Terms of guarantee
Please keep carefully the letter of guarantee completed by the seller, or the certificate of purchase.
The
GAMA
GARDEN
will provide 12 months
’
guarantee from the date of purchase. This guarantee is in compliance with the
technological condition and the purpose of use / field of application. The following guarantee instructions will not
influence customer
’
s statutory rights.
Preconditions of the 12 months
’
guarantee:
The device is used exclusively for private purposes.
The guarantee period will be reduced to half if the machine is used in the commercial sector and in the field of
leasing business.
- Our guarantee is provided under the condition that the machine is handled properly and the instructions given in the
instruction manual are observed.
- The maintenance intervals determined are observed.
- It is forbidden to change the design without permission.
