6
Version 1, 21 August 2019, 6 of 21
7. Connect transformer
−
Do not remove the black label in front of
sensor faceplate until the tap is to be
commissioned.
Connect the transformer to the sensor.
8. Testing and operation
−
Turn on hot and cold water supply and power to the
transformer.
−
Remove black label.
−
Start sensor; Refer to the Sensor Setting Instructions table
(section 6.1)
–
First startup and set electronic settings
for tap.
−
Check for any leaks.
−
Comission tap as per section 7.
6.1 SENSOR SETTING INSTRUCTIONS
Signs
and
symbols
Touch function
Hand/object within sensor area
Water flows
LED flashes Green
Water flow stops
LED flashes Red
H
– hours / min. – minutes / sec. - seconds
FUNCTION
PROCEDURE
FEEDBACK
SIGNAL
INFORMATION
DEFAULT
SETTING
RANGE
Via IQUA
Touch
First startup
After
installation
1x
app. 4 sec. till
Remove hand/object from sensor
area
-.
-
wait
+
2x/sec., keep out of sensor
area
wait till
1x
Confirmation, ready for operation
Temporary
off
«Cleaning
mode»
Activate
1x
app. 2 sec. till
1x
Extended function mode is active
2 min.
2x
a app. 0.5 sec
Pulsing during active function
Temporary
off
Stop
1x
app. 2 sec.
1x
Manual stop
or automatic
1x
Automatic after preset time
1x
app. 2 sec. till
1x
Extended function mode is active
5 min.
XX
X
