© Galvin Engineering Pty Ltd
Product Installation Guidelines
Document No.: 001.00.10.25
Version 1, 19 October 2022, Page
14
of
24
5. Remove the cartridge by hand and clean all
components thoroughly. Inspect components for
damage. If components are damaged, the cartridge
must be replaced.
6. Cleaned cartridge (or a new cartridge, if this is
required) can now be re-installed, by screwing into
the mixer body until it reaches a firm stop and
tightened. The cartridge should be tightened to a
torque of 15Nm. Re-install or install new plastic
lock.
Note:
Plastic locks are available. For more information,
please visit www.galvinengineering.com.au.
7. When service is complete, slowly turn the cold-water
s t n v ve t ‘OPEN’ p s t n nd nspe t
mixer body for leaks. Repeat with hot water isolation
ball valve.
8. Re-commission the mixer as per commissioning
procedure (See section 8.0 Commissioning).
