© Galvin Engineering Pty Ltd
Product Installation Guidelines
Document No.: 001.00.10.25
Version 1, 19 October 2022, Page
8
of
24
7. Fit the faceplate
-
Fit the faceplate in position, it will be
held in place by a set of magnets.
-
Ensure the backnut is supporting the
faceplate.
-
Insert the flange and screw in the
locking nut.
-
Lock the locking nut using grub screw.
8. Install Spout and plug
-
Ensure there are two O-rings on the
inner part of the spout before installing
the outer spout.
-
Push spout to the end and lock with
grub screw to secure.
-
Ensure the disinfecton key cover is fitted
to the open hole as shown.
7.1
OPERATION AND TESTING
After installation, check for leaks and correct operation.
Hand Movement activates the mechanism and delivers the water with
the pre-set temperature.
7.2
SENSOR SETTING INSTRUCTIONS
Signs and
symbols
Touch function
Hand/object within sensor area
Water flows
LED flashes Green
Water flow stops
LED flashes Red
H
–
hours / min.
–
minutes / sec. - seconds
XXX
Spout
Grub screw
Plug
Plug O-ring
O-ring
