GALTA BLP 1000, Быстрый старт

Страница: 4 / 14

Functional Check of Lift
Without external load applied to lift platform, fully raise and lower multiple times to ensure proper function of
the hydraulic system and scissor components.
1. Press the end of the air pump foot pedal marked to raise the lift platform until it stops at maximum
extension.
2. Press and hold the end of the air pump foot pedal marked to lower the lift platform until it reaches
full collapse.
3. Ensure platform raises and lowers only when the air pump foot pedal is actively depressed by the operator.
WARNING: To prevent personal injury and/or equipment damage, if platform moves after air
pump pedal is released, discontinue use and service immediately.
Preparation of Other Features
A. Platform Tilting Features
1. Turn forcing screws in/out fully to ensure proper function of platform tilting feature. See Figure 1 of
“Fine Adjustment Tilting Feature” section.
B. Stabilization Feature
1. Insert leveler screws into sockets (approx. 5 turns). Leveler screws should not project above steel
tube or contact platform underside when not in use. See Figure 2 of “Stabilization Feature” section.
C. Platform Sliding Extension Feature
1. Cut shipping banding securing platform halves
2. Retract spring plunger and extend platform by pulling on table handle. Ensure spring plunger engages
at all three stop positions when the plunger is released.
Fine Adjustment Tilting Feature
Operating Instructions
The forcing screws shown in Figure 1 allow the user to finely tilt the platform to help remove or install vehicle
components.This feature provides a total of two inches of tilt at the front of the platform which helps compensate
for uneven shop floors, difficult fastener locations, etc. The forcing screws can be operated by either hand, or
wrench or socket, depending on the applied load.
CAUTION: To prevent equipment damage, do not tilt the platform without the leveler screws in their
lowest position as the platform might be driven into the screws.
Forcing
Screws
Back Sheet 2 of 7
Figure 1