© Copyright
Gallo Technologies
. All Right Reserved
- 8 -
Rev. V8.2- 20212
10. RFID Scan time:
Short (default):
Sets the interval between the RFID transmitter scans to a shorter period of time. Normal battery life
& shorter detection time. Preferred.
Long:
Sets the interval between the RFID transmitter scans to a longer period of time. Extended battery life but
longer detection time.
Note: If there is no RFID detection activity for 72 hours or more, the RFID scanner will turn OFF. Pressing
any button on the Key FOB will reactivate the RFID scanner.
11. Anti-hijack:
Enabled (default):
Turns ON Anti-Hijack Function. Anti-Hijack can be activated using the key FOB.
OFF:
Turns OFF Anti-Hijack Function. Anti-Hijack can not be activated using the key FOB
12. Ignition 2 Start Requirement:
Disabled (default):
Ignition 2 output turns ON during the engine start sequence and ON after the engine start
sequence.
Enabled:
Ignition 2 output is OFF during the engine start sequence but activated (ON) after the engine start
sequence.
13. Return Factory Default
: Resets all Function Options to factory default settings.
14. Car Window Close Time:
5 Sec (default)
Window close output pulse length set to 5 sec.
3 Sec (optional)
Window close output pulse length set to 3 sec.
15. Car Window Auto Close:
OFF (default)
Car window close function is turned OFF. Windows will not auto close after driver leaves the vehicle.
ON (optional)
Car Window close function is turned ON. Windows will auto close when driver leaves the vehicle. The
window close output will only activate
after the engine has been turned off
and the driver leaves the vehicle.
NOTE:
This function should only be used in conjunction with a
window close module
(not included) that limits the
current to the window motors in the event of an obstruction being in the way when the window is closed.
A. Code learning (code learning mode, for the new transmitters)
1. System must be in Disarm mode (green LED flashing).
2. Press the valet switch 3 times, then hold the valet switch for over 5 seconds, it will enter the code learning mode.
The green LED will light up and the parking lights will flash 2 times.
3. Immediately (within 5 seconds) press the
button on the new key FBO that needs to be code learned. When
the parking lights flash 4 times, code learning was successful. Repeat this process for the second Key FOB.
Both key FOBs must be code learned.
B. Function Programming:
1. System must be in Disarm mode (green LED flashing).
2. Press valet switch 5 times, then hold the valet switch for over 5 seconds, parking lights will flash 2 times.
3. According to the “Function Option Chart” below, you can set up the required function by pressing the Valet
Switch the number of times indicated in Table 1.
4. Immediately after pressing the valet switch the number of time indicated press the
button on the key FOB. If
the parking lights flash 3 times, the default setting for that function has been set. If the parking lights flash 1 time,
the alternate setting has been set.
Note: After entering the “Function Programming” mode, the
button must be pressed on the key FOB within 5
seconds. If not, the system will exit the “Function Programming” mode and the parking lights will flash 4 times.
Repeat steps 1 thru 4 for each additional programming function.
1.5 Key FOB & PROGRAMMING FUNCTION SET UP
