IWCi
22
It is strictly forbidden to reproduce this manual, even partially
WC66000122 - Rev 03
REMOTE CONTROLLER
ELECTRONIC BOARD - PCB
REMOTE CONTROLLER: SWITCHING FROM INFRA-RED TO WIRED
PREPARING THE REMOTE CONTROLLER
•
Detach the plastic cover from the terminal board for the remote controller.
•
Open the battery compartment, take the batteries out and set micro-
switches 5 and 6 on OFF.
•
Close the battery compartment without putting the batteries back in (the
remote controller will be wire-powered).
CONNECTION
Use a 0.5mm² shielded three-pole electric cable, with max. length of 15m.
The cable must not be any lighter than H05VVC4V5-K (according to IEC 20-20
CENELEC HD21).
CONNECT THE REMOTE CONTROLLER TO THE 5-POLE
TERMINAL BOARD INSIDE THE ELECTRIC PANEL, AS
FOLLOWS:
• Take off the yellow jumper cable.
• Connect the clamp with the pink cable end to the bottom unit of the terminal
board on the remote controller (+ pole).
• Connect the clamp with the violet cable end to the central unit of the terminal
board on the remote controller (IR).
• Connect the clamp with the white cable ends to the top unit of the terminal
board on the remote controller (- pole).
• Connect the cable shield to the clamp with the yellow/green cable end or,
alternatively, if possible, to an earthing point on the remote controller side.
REMOVE YELLOW "JUMPER" CABLE
TAKE THE BATTERIES OUT
5, 6 OFF
5-POLE (MAMMUT) TERMINAL BOARD
INSIDE THE ELECTRICAL PANEL
REMOTE CONTROLLER: ADDRESS SELECTOR
Before opening the unit, make sure that the unit is switched off and
that the main current switch is on OFF.
If several units are installed (up to 4) in the same room, it will be
necessary to aim each remote controller towards its own inside unit.
YELLOW
INDOOR
UNIT
REMOTE
CONTROLLER
ELECTRONIC
BOARD
PCB
FACTORY SETTING
YELLOW / GREEN
WHITE
VIOLET
PINK
