GALLERY Classic Eco, Руководство по установке

Страница: 23 / 32

23
REMOTE CONTROL STOVE
LIGHTING THE PILOT
Depress control knob fully. Whilst depressed turn knob slowly through 90° anticlockwise to PILOT
setting. A click will be heard and the piezo spark should light the pilot. Repeat until pilot is visibly
lit. If necessary the operation of the spark can be viewed by temporarily opening the front door. Keep
knob depressed at this point for 10-15 seconds and release the knob. The pilot light will remain lit.
HIGH SETTING
If the stove is not already lit light the pilot as described above.
Turn the control knob anti-clockwise until the HIGH setting is reached.
LOW SETTING
If the pilot is not already lit, light the pilot as instructed.
With control knob at PILOT setting, depress and turn anti-clockwise to LOW setting and release the
knob.
TURNING THE STOVE OFF
From any heat setting, depress control knob fully and turn clockwise to PILOT position.
TURNING THE PILOT OFF
From any heat setting or the PILOT position, depress control knob fully and turn clockwise to OFF
position.
Should the stove be extinguished for any reason, wait 3 minutes before attempting re-ignition.
IMPORTANT
When starting the fire the burner usually takes around 3-10 seconds to ignite and adjust to the
maximum setting. This can take longer on the first lighting.
STOVE CONTROLS
This stove is fitted with a gas valve which can be operated via the remote control or using the control
unit which is located behind the right-hand foot of the stove. Fig. 3 shows the main features of the
controls.
• The control requires 3 AA size alkaline batteries to be inserted under the battery compartment
cover. The orientation of these is shown moulded into the battery compartment
• After fitting the batteries and replacing the cover the fire can now be operated
• Slide the Master switch to the right to the ON position (I symbol)
• To start the fire, press the ON/OFF button and hold for 1 second then release. The burner will
within around 1 to 10 seconds ignite and adjust to the maximum power setting
• The power of the burner can be adjusted up and down by pressing the + and - buttons
• To stop the fire, simply press the power button again and the burner will stop
NOTE: For safety reasons a button must be pressed and released for the command to be recognised.
Keeping hold of a button when pressing (unless otherwise instructed) will not be recognised as
a command press.