26
E-Z SWIVEL
30°C / 85°F
Maintenance and adjustment
Filter bag
label
Screws
outlet top
propeller
Cable Assy
Core
Handle Cover
E-Z swivel location
patent pending
(continued from the previous page)
d. Remove the filter bag from the support bars, turn it inside out and wash off all
the dirt with a garden hose or in a sink. Squeeze the bag gently until the rinse
water is clear. If necessary, machine wash the bag using only cold water with NO
DETERGENT! (fig.5)
e. Re-install the bag on the support bars with the label in the center of one of the
long sides of the bottom lid (5a)
f. Re-install the bottom lid assembly in the body. Push down on it until lock tabs will
snap into place properly.
IMPORTANT TIPS:
• Shut off and unplug the power supply every time you remove the cleaner from
the water.
• Clean the filter bag after every cycle.
• Reverse the handle after every cleaning cycle to avoid tangling the cable.
• Periodically straighten out the floating cable.
• Replace worn brushes to ensure maximum cleaning performance
• Make sure that your pool cleaner positions itself properly on the wall. The
machine handle must rest parallel to the water line upon reaching the surface of
the water.
• Save your cleaner‘s packaging for off-season storage or for shipping the unit to
your dealer if service is required.
• Leave your pool cleaner in the water for 15 to 20 minutes after every cleaning
cycle.
•
Do not leave your cleaner in direct sunlight when not in use.
•
Never leave the power supply in direct sunlight and avoid leaving it in the rain.
• Occasionally, you should rinse your cleaner in clean, fresh water. This will
lengthen the service life of the drive belts, drive tracks and scrubbing brushes.
•
Clean the propeller once a month
Cleaning the pump propeller:
1) Take out the 2 (4) screws from the outlet top
2) Take out the outlet top and remove hair and other debris around propeller
CABLE CARE
The cable may become twisted after a period of time in use. To correct this
condition, simply lock the moveable handle on the top of the cleaner in the
opposite diagonal direction. The pool cleaner will now travel in the opposite
direction while cleaning your pool and the cable will uncoil. Check the cable
periodically for external damage If the problem persists, use the E-Z Swivel
device.
Place the robot on the ground and unplug the
cable from the transformer. With one hand,
holding the E-Z Swivel, walk away from the
robot, pulling the cable to its full length. The core
will rotate inside the cover and in this way will
untangle the cable.