ELECTRIC ROLLERDOOR – J BRACKETS
Installation
-
12
-
ENG
7.1. Doors up to 5.0m wide, Figure 8a:
Fasten the free end bracket (E1) to the holes drilled in building at free end, using
the M8 fixings supplied. Push free end collar (E2) into the top tube at the free
end. Lift the assembly into position and slide top tube onto free end bracket.
When in position fasten drive bracket (F1) and motor cowling bracket (G1) to
building.
Figure 8a, Mounting Doors Up to 5.0m Wide to Building
CAUTION: Referring to Table 1 on page 4, ensure the building
is of sound construction and that the most suitable type of
fastener is used. Use only M8 bolts or greater to fit these items
and ensure they are securely fastened to the building. Failure
of these fixings will result in your door falling off the building,
potentially injuring operators and bystanders.
7.2. Doors over 5.5m wide, Figure 8b:
Slide safety spring (D1) into the top tube, opposite end to the motor. Lift the
assembly into position, and bolt both brackets on using the M8 fixings supplied.
NOTE: If you wish to fit the safety spring to the opposite side to
that ordered, refer to instructions in Appendix I.
The motor cowling bracket (G1) is fastened to the drive end at the same time.
Motor Wire
