Galeb GP-200
User Manual
Page 33
10.3 GPRS reports
In this menu user has the possibility of printing the current state of the
GPRS modem. The menu contains two sub-menus.
The sub-menu is used to print GPRS settings to Tax Administration
(TA) server as well as readings from the network operator. Printing
setting values confirming using TOTAL key, and the C button using to
exit the sub-menu without printing the document.
Values obtained in printing, also represent a test of the modem device.
In the case that the part of the SIM (ICCID) get marked as ERROR
value, indicates that the device has detected an error while reading the
SIM card, and modem devices can not send data to perform a GPRS
network. For this case, contact an authorized service center.
If the signal level is less than 10, the device
will not send data to the server TA.
The bad signal problem can be solved using external antenna.
Network operators can have the value
NO
NETWORK
. In this case the device cannot log on
to the network operator. (Check PIN and PUK on the card and contact
the authorized service)
Sub-menu to print the current state of the device sending the server Tax
Administration:
It is obtained by double pressing 3, confirmation with TOTAL key, and
the key to pull the paper may move up to the required report, which can
be checked, among other things, the next time a GPRS connection to
the server unit PU.
10.4 Shows the current voltage
In the menu 3.4 ECR gives the user information on the value of the
supply voltage used. Entering this menu the user can check the stability
of the external power supply to be used.
Using confirmation button enter in the sub-menu that defines the time
for which the device is automatically turned off if the user does not