Galcon AMC-6DC, Руководство пользователя

Страница: 4 / 48

Safety Instructions
General Safety Instructions
l
Use the controller only for its intended use as designed by the manufacturer, any misuse of the
controller may lead to undesired damage and may affect your warranty coverage. Consult with the
manufacturer prior to any non-regular use of this equipment.
l
The terminals enclosure lid of the unit must remain closed at all times.
l
Only a qualified technician may remove this lid and only when the controller is properly disconnected
from its power source.
l
Servicing the unit can be done only by qualified technician.
l
Make sure that the filters controlled by the controller are disconnected from the water system whenever
servicing the controller.
l
In case the controller is connected to an external AC power supply unit, make sure that the power
supply connection is done only by a licensed electrician and the connection complies with your local
standards for High Voltage out-doors connection.
l
Please note: The filter enters into a flushing mode automatically, without early warning.
l
No change or modification to the equipment is permitted without a written notification given in advance
by the manufacturer or by its representative, on the manufacturer’s behalf.
l
Always observe standard safety instructions and good engineering practices whilst working in the filter’s
vicinity.
Electricity Instructions
l
Electric wiring should be performed by an authorized electrician only, using standardized and approved
components.
l
Install a lockable main power cut-off switch close to the control panel.
l
If due to site constraints, the control panel is installed without a clear line-of sight of the filter, an addi-
tional lockable power disconnect cut-off switch should be installed near each filter unit.
l
Use only the built-in transformer.
l
In case the controller is supplied with a power supply cable connected to it, the controller is for indoor
installations only!
l
In order to use the controller for outdoor installation, a licensed electrician must disconnect the power
supply cable, and connect the controller according to the instructions given in the installation chapter of
this document and in compliance with all the safety instructions and the local standards for High Voltage
out-door connection.
l
If the plug does not comply with your local regulation, it must be replaced with suitable plug by licensed
electrician only.
l
Hazardous Live voltages connected to the following output terminals :
l
Filter Motor Control terminal (230VAC/115)
l
24VAC for solenoid control and for 24VAC auxiliary (24VAC IS CONSIDERED HAZARDOUS LIVE IN WET
LOCATIONS!).
4 AMC Flushing Controller User Guide
Contents