Galaxy PH40V, Инструкция по эксплуатации

Страница: 23 / 28

21
Mark the first sheet you run through the machine with a cross on the top
side, so that you know in which direction it has been fed. If it leaves the
machine with the fold diagonally shifted from the straight line, first fold it
by hand to an even more acute diagonal offset from the straight, then
place it again on the feed table in the correct running direction. Since the
fold always runs parallel to the spindles, you must now turn the sheet (and
adjust the guides correspondingly) until the next trial fold runs exactly
parallel to the spindles. The next sheet will already show an improvement.
Possibly, you may have to make another trial fold, continuing with the
sheet alignment until the diagonal shift is completely corrected.
Setting to pointed tips or out-of-square paper
Where the sheet end has pointed tips (diagonal cuts) or out-of-square, use
the angle micro-adjust to adjust to the correct angle.
Correcting minor fold variations
Once you have accurately set the plate stops to the desired style of fold by
the scales, it should not normally be necessary to equalize minor fold
variation, provided the running speed is not changed drastically after
setting up.
Placing and replenishing the paper stack
When feed table, automatic-paper feed, plates and delivery have been set to
the required fold, place the first paper stack on the table - between 100 and
300 sheets, depending on paper grade, evenly fanned out. Align the stack
at the sides. To avoid the last sheets of a stack being drawn together under
rollers and spindles, it is advisable to stick a single sheet with adhesive