4
G8-09-11-2018
Latching
You MUST move quickly during this process!
Please read through instructions thoroughly before starting. The control
board will exit the programming mode after 7 seconds of inactivity; you
may have to practice the steps a few times before programming your
remote successfully.
1.
Have all remotes present.
2.
Press and hold the learn button on the gel pad until the green
LED beside the button lights up (approximately 3 seconds).
3.
Press either the up or down button on your remote, you will see
a corresponding flash from the learn LED.
o
Additional Remotes:
Repeat this step with each remote.
4.
Press either up or down on the remote again.
o
Additional Remotes:
No further actions required on this
step.
5.
You should see a corresponding flash on the learn LED that is
quicker
this time.
6.
Give the learn mode about 10 seconds to expire, you will see a
rapid flash from the learn LED.
7.
Now test the remote(s) to see if the programming was successful!
