Edit Parameters
- in this sub-menu, all the parameters related to the signal processes of the
DS-CP22 are available for editing.
Pressing the “ENTER” button, the processes can be accessed for editing.
With the “NAVIGATION” Encoder, all the processes can be scrolled through and from the
“Edit Parameters” Sub Menu, the DS-CP22 channel can be selected for editing by simply rotating
clock/counter-clock wise the “PARAMETERS” encoder.
Upon entering the Edit Parameter Sub Menu, the screen will show the following:
In the case above, the parameters edited are for Channel A (ChA). For editing Channel B (ChB),
rotate the PARAMETER encoder and the screen shows the following,
Indicating that the Parameters edited will refer to ChB .
It is also possible to select Ch. A+B, and in this case the edited parameters will be assigned with
the same value to Channel A and B.
In the Editing Parameters Sub-menu, the available processes are:
Routing:
Assigns the processor to Channel A, B or A+B
Input Gain:
Digital control of the Input level
Noise Gate
A.G.C.
Filter 1 – Filter 7:
Eq. Filter 1 is selectable as 1st or 2nd Order high-pass or low shelving and
the filters from 2 to 7 as 1st or 2nd Order shelving or peaking
Sub Harmony:
Sub Harmonic Synthesizer centered around 65Hz or 90Hz
Drive:
Signal Control before the RMS Compressor
RMS Compressor
Volume:
Make Up Volume after the RMS Compressor and before the Peak Limiter
Peak Limiter
Mute:
Output Channel Muting.
Ch.A Edit Param
Routing
Ch.B Edit Param
Routing
14
Содержание DSPOT DS-CP22
Страница 30: ...Select the EQ block to access the lters 29...
Страница 31: ...Select the Compressor Block to access the Compressor page 30...
Страница 32: ...Select the Limiter Block to access the Limiter page Select the AGC Block to access the AGC page 31...
Страница 38: ...DS CP22 Processes Block Scheme 37 Block Scheme...
