GALAXIS SHOWTECHNIK PYROTEC G-Flame, Руководство пользователя

Страница: 39 / 60

39
There are two possibilities why a measurement has been cancelled:
Terminated: no
charging voltage
The charging voltage was interrupted for an unacceptably long time. To
avoid damages the device cancelled the test. Maybe the charger has been
disconnected or a power failure of the mains supply occurred. Establish the
power supply and start the test sequence again. If your mains supply is
unreliable it is recommended to use an UPS (= Uninterruptible Power
Supply).
Terminated by
user
Somebody cancelled the test before a result was gained.
If a power failure of the charging voltage occurs during charging or discharging you will hear an
acoustic signal in the first instance. When the interruption lasts for too long the device terminates the
measurement to avoid damages. If no UPS (= Uninterruptible Power Supply) is being used you should
check once in a while if everything is OK.
24.2. Menu items if DMX512 has been selected as an input
The following menu items are only being displayed if DMX has been selected as the input.
24.2.1. The menu item 'Flame Channel'
Flame Channel:
001
With 'Up' and 'Down' you can select a DMX channel ranging from 1 to 512
which should be used to control the flame effect. Confirm your selecting
with 'Mode'.
The functionality is described in detail in the chapters 'The DMX512 input' and 'Control via DMX512'.
24.2.2. The menu item 'Safety Channel'
In addition to the flame channel a so called safety channel must be programmed.
Safety Channel:
013 60-80% =
With 'Up' and 'Down' you can select a DMX channel ranging from 1 to 512
which should be used as the safety channel. Confirm your selection with
'Mode'. If you have for example 12 G-Flames in use it is meaningful to use
the DMX channel 1 to 12 as control channels and the next DMX channel, in this case 13, as a safety
channel on all devices.
A value between 60% and 80% (decimal values between 153 and 204) has to be received on the
safety channel in order to enable flame effects.
The functionality is described in detail in the chapters 'The DMX512 input' and 'Control via DMX512'.
It is not permitted to use the same channel number for the flame and the safety channel. In this case
the following will be displayed on the LCD:
Identical DMX
Channels!
This screen is being displayed for some seconds. After that the device
jumps back to the menu item 'Flame Channel' so that different channels can
be programmed.
You can only exit the menu if different channels have been selected.