2
11
When using electrical appliances, basic safety precautions should
always be followed including the following:
1. Read all instructions.
2. Do not touch hot surfaces. Use handles or knobs.
3. To protect against electrical shock do not immerse cord, plugs, or(state
specific part or parts in question) in water or other liquid.
4. Close supervision is necessary when any appliance is use by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts.
6. Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions or has been damaged in any manner. Return
appliance to the nearest authorized service facility for examination, repair
or adjustment.
7. The use of accessory attachments not recommended by the appliance
manufacturer may cause injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Extreme caution must be used when moving an appliance containing hot oil
or other hot liquids.
12. To disconnect, turn any control to
“
off
”
, then remove plug from wall outlet.
13. Do not use appliance for other than intended use.
14. Save these instructions.
10. Malfunction and resolution
Cooker can not work but
the screen works well
Button fell off or unsoldered
Button broken
PCB broken
Function key out of order
Circuitry fell off or broken
Can
’
t work after turned on
Plug in or not?
Fuze or switch broken or not?
Power off or not?
Stop heating when in use
Surrounding temperature too high or not
Air inlet
、
exhaust jammed or not
Engine blocked or not?
When keeping warm it indicates temperature
reaches the adjusted and will reheat later.
Sometimes protecting device works ,please
readjust.
?
?
Temperature can
’
t
be controlled
The bottom of the pot is not smooth,or
the middle part of the bottom is concave.
Phemomena
Causes check
Malfunction code
：
E0~E8
E1
、
E6
：
minutes later,the temperature
recovers and cooker resumes.
E2
、
E3
：
restart when voltage is normal
E0
、
E4
、
E5
、
E7
、
E8
：
send to repair.
1. Important safeguard
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with Part 18 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
