SS91BV-M GSM Intercom
7
Revision E8
,Jan 2015
LED INDICATORS
1.
LED “Intercom Status “ Indicator
LED
Status
Yellow (standby)
Flashing
Yellow (using)
Solid
2.
LED ‘Network “Indicator
LED
Status
Green (ready)
Flashes once per 3 seconds
Green (searching) Flashes once per second
Green (busy)
Solid
3.
LED “ Power “ Indicator
LED
Status
Red (power on)
Solid
Red (power off)
Off
1. SIM card
Register your SIM card with the network, and check it works in a mobile phone
You MUST remove the PIN request from the SIM before inserting it in the unit SS91BV-M.
Ensure the power is OFF before inserting the SIM card. Carefully side the SIM holder in the
OPEN direction, insert the SIM, and slide in the CLOSED direction to lock it in place.
2. Antenna
Install the antenna as high as possible on the top of the pillar for best possible reception.
3. Door Lock
Connect an electric door lock to terminals marked “door latch”.
4. Power Supply
Connect a 12 volt DC power supply to terminals marked “AC, AC”
The power supply should be capable of supplying a constant current of no less than 1amp.
5.
After a final check of wiring , switch on the power
6. Allow 20~30 seconds for the unit to boot up and detect the network. Once successful connection
has been made, the unit will sound a confirmation tone and the status LED will begin flashing.
