SS91BV-M GSM Intercom
12
Revision E8
,Jan 2015
Progrmming by dial in
Note: p
rogramming dial in can’t be used from telephones which are already programmed to
open the door when they dial the GSM intercom but you can disable Caller ID display (withhold
the number) on the mobile before using.
To gain access to the programming mode via dial in, follows these steps:
Example:
Storing a telephone number for dial in door release
Enter Programming Mode by Pressing
…..
*12*
1234
# (1234 is default password)
A successful pass code will produce a single long beep. A failed attempt will produce 3 short
bleeps.
You may now program up to 100 telephone numbers into memory.
Use the following commands to program the unit
* Insert international country code (1~3 digits):
71 [ country code] #
* Add a number (up to 100 numbers):
72 [ telephone number] #
* Delete a number:
73 [ telephone number ] #
* Delete all numbers:
73*#
Door /Gate Release (ring in to open)
This GSM intercom also has an extra feature to allow user to gain access from their mobile
phone by two methods.
1. Caller ID recognition
2. by access control password mode
1. Caller ID recognition to open
Ring in to open the door for authorized telephone number.
It can support for up to 100 users.
When GSM Intercom receives a call from user, it will check the calling number and if the number is
in the list, the GSM Intercom will drop the call and then open the gate / door. The GSM Intercom
doesn’t answer the call, it simply checks the caller ID, and so it won’t cost you anything to open the
gate / door.
