GAI-Tronics Titan GSM, Инструкция по установке и эксплуатации

Страница: 26 / 36

26 Titan GSM
to be automatically called when lifting the handset, on the zero
button keypad version. Example: 1234auto=07771230231
CLOCK Only via SMS, sets the clock to the time recorded in the SMS
delivery from the mobile network. For setting via USB, see ETSI
+CCLK
INIT Restarts the phone (cold boot).
OUTn ON/OFF Sets the output of relay n (1 or 2) on or off. If a single
bistable relay is installed, selecting relay one or two will make
no difference.
PHPIN Read (only via USB) and write phone PIN, fixed length of 4
digits (default 1234).
PNUMn Programming Memory Locations : Is used to read or write
phone numbers stored in the phone memory locations. There
are eleven memory locations in total. Ten of the locations (n=0
to n=9) are reserved for storing the phone numbers for memory
keys/buttons on an appropriate keypad. For example to store a
phone number in location n=0 the SMS message would be:
1234pnum0=07771230321
The SMS command will be acknowledge by pnum being sent
via SMS, unless a stop character is inserted after the PIN
number (1234.pnum….).
To read or check the number stored in any one of the locations
send the following SMS command, for example to check
location n=0 send: 1234pnum0? (Or to read all stored numbers
send SMS command 1234pnum*?) The phone will respond via
SMS with a particular stored number or all stored numbers
depending on the command sent, for example
PNUM0:07771230321.
Programming Auto-dial Number : Location n=10 is reserved
for the phone number to be Auto-dialled as soon as the handset
is lifted off-hook; primarily for the zero button model. To program
location n=10 via SMS follow the same format as above, for
example: 1234pnum10=07773450543 Note: CFG7=1 must also
be configured to enable the auto-dial feature. Alternatively the
programming of PNUM10 and the setting of CFG7=1 can
automatically be combined by using the shorthand command
AUTO=nnnn (where here nnnn is the phone number), for
example: 1234auto=07773450543
PVER Returns the prompt version and language (<ver>,<lang>).
Note: This feature is an additional option and is set at the time
of manufacture. It must be specified at the time of ordering.
VER Returns the firmware version number.