GAI-Tronics Titan GSM, Инструкция по установке и эксплуатации

Страница: 22 / 36

22 Titan GSM
Example 2: AT!1234CFG5=1<cr> sets the phone to inhibit incoming calls.
Notes for USB commands
•
Echo “E” and command response ”Q” (OK/ERROR) behave
differently when the phone is in charge only mode or active. In
charge only mode, echo and response is turned on with ATE1Q0 or
off with ATE0Q1, the default is no response. This is to maintain
compatibility with legacy flash programming software. When the
phone is active, “E” and “Q” comply with normal ETSI standards.
•
Commands may be concatenated by entering a semicolon delimiter,
for example AT!1234CFG5=1;STAT<cr>
5.3. List of Commands (for use with SMS and USB)
STATn Returns the status of the phone. If n is omitted, it is interpreted
as zero.
n => 0 for general status, useful during installation:
State:
s
(phone state, see table below)
Signal: -89dBm
Supply: 12.2V
Bat: 4.191V
Temperature – (in degrees Celsius)
Now: 20
Min: 18
Max: 26
No fault/Fault
Ver: 1.0
Note that normally the signal should be between -90 and -50,
the supply should be between 9 and 18V, and the Battery
should be between 4.00 and 4.40V.
If a fault is shown, send 1234stat1 for more details.
State ( s ) value returned from a STAT0 command:
Value Meaning
1 Outside operating temperature limits.
2 Charge only.
3 Insufficient power to operate in solar charge
mode.
4 Error condition, communication failure with
wireless module.
5 Phone is initialising.
6 Checking SIM present.
7 No SIM installed.
8 Checking SIM lock.
9 Waiting for SIM PIN.
10 Waiting for SIM PUK.