GAI-Tronics Titan GSM, Инструкция по установке и эксплуатации

Страница: 10 / 36

10 Titan GSM
4.4. Mounting methods and dimensions
Before mounting the telephone, check the cable routing and requirements. If
glands are required, fit them to the case as follows:
1. Usually both glands are used – one for the antenna cable and the other for
power. If only one gland is to be used, remove the RED blanking plug
leaving the other (usually BLACK) in place.
2. Note that 2 plastic glands are supplied, but it is the installer’s responsibility
to select the correct type of gland for the application and cables used.
3. Select the appropriate sized gland:
Use the smaller gland for cables
diameters 4 - 7mm.
Use the larger gland for cable
diameters 8 - 13mm.
4. From the outside of the case, insert
the selected gland into the threaded
cable entry hole and tighten, so that
its sealing washer is compressed
against the enclosure surface.
5. Proceed with chosen mounting method below
4.4.1 Wall mounting
1. Using a suitable tool, punch out 4 holes in the rear enclosure, taking
care not to damage or dislodge the plastic bushes. Only four of the
eight holes are required - the outer ones are recommended. The
inner holes are provided to be compatible with older-style mounting