GAI-Tronics Help Point PHP400 GSM, Инструкция по установке и эксплуатации

Страница: 22 / 34

PHP400 GSM Help Point. 22
10 = Acoustic loop test (0 for pass, 1 for fail, 2 for test not applicable)
11 = Keyboard (0 is OK, 1:n for fail where n is the key number)
12 = Call state (0 for idle, 1 for call in progress,)
13 = Battery state (0 for OK, 1 for fault)
14 = IMEI (eg 357749031743900)
Note that faults are shown in the codes between 7 and 13.
For a more human-readable summary of faults, use STAT1 if required.
The error condition(s) which initiate(s) automatic sending of status are
selected with CFG22
CFG10 SMS command enable (via USB only): If the phone is to be used with a
PC connected via USB with software that handles SMS, disable the SMS
commands.
0 = Disabled
1 = Enabled(Default)
CFG12 Maximum dialled number length . The maximum number of digits
accepted may be changed (default 20).
CFG15 Activate relay for ring indication.
One of the relays may be used to activate an external sounder. The relays
switch at selected ring cadence.
0 = No action (default).
1 = Use relay 1 with ring cadence.
2 = Use relay 1 continuously.
3 = Use relay 2 with ring cadence.
4 = Use relay 2 continuously.
CFG16 Power supply type . When selecting 1 for external battery, low
voltage power alert provides notice for an external 12V battery requiring
replacement/charging.
0 = Normal and solar DC supply (default).
1 = External battery
CFG17 Automatic send of call log at threshold: Calls are automatically
logged to a total capacity of 240 entries on a first in first out basis. If the log
is not automatically sent, or read using the “CLOG” command, the oldest
entries will be overwritten. The call log data is mainly intended to be
processed by computer software. See section on call log format.
0 = Automatic sending of call log disabled (default).
1 - 240 = number entries at which point call log sending is triggered
This function may also be enabled when the automatic sending is enabled,
but normally only one method would be used
CFG18 Automatic timed sending of call log: When enabled, the call log
will be sent at the time specified with LTIME default is midnight).
0 = Disabled (default).