GAI-Tronics Help Point PHP400 GSM, Инструкция по установке и эксплуатации

Страница: 27 / 34

PHP400 GSM Help Point. 27
•
*1 The
character sequence “*1” can be used at the end of the memory
number to add a one second pause after the call is connected. Any digits
after the *1 are then sent as DTMF tones. Additional pauses may be added
by including multiple *1s.
For example, +4412345678901*1*123 will dial the UK (+44) to
12345678901, then pause for 2 seconds, then send DTMF tones 23.
•
The
*
character maybe sent using
**
Memory allocations:
PNUM11 - Number to send automatic SMS.
PNUM0
– Help/Emergency/M1 primary number.
PNUM1 - Information/M2 primary number.
PNUM2 - M3 primary number.
PNUM3 - Help/EmergencyM1 1st rollover number.
PNUM4 - Information/M2 1st rollover number.
PNUM5 - M3 1st rollover number.
PNUM6 - Help/Emergency/M1 2nd rollover number.
PNUM7 - Information/M2 2nd rollover number.
PNUM8 - M3 2nd rollover number.
Special behaviour
Rollover
Each memory button can have up to 2 rollover numbers as shown
above. If the call to the primary number fails (eg the call cannot be
connected or is busy) or if it is not answered within the time defined by
CFG28, the phone will then try to place the call to the 1st rollover
number for that button. Again if that call fails it will try the 2nd rollover
number. If all the rollover attempts fail the phone will retry the whole
sequence again starting with the primary number
– the number of retries
is set by CFG27.
Emergency override
For two button Help Points with buttons designated "Emergency" and
"Information", pressing the Emergency button when the phone is in an
Information call will cause it to drop the current call and make a call to
the designated Emergency (M1) number.
BPOWER Initiates a test of power consumption from the battery. If the battery is over 80%
charged, the internal supply voltage is reduced to force the phone to draw power
from from battery for 30 minutes. The average current taken during this time is
recorded and may be read with STAT4.
REPORT=n Shorthand way of combining PNUM11=n
and CFG9=3,where n is the phone number. For example
REPORT=07123456789”Bobs mobile”. The name field may be omitted. The
STAT1 will be sent if an error condition occurs.
Entering REPORT without a number turns off the automatic error reporting
and is equivalent to CFG9=0. For example, REPORT=
RESTORE=n Restore settings of the phone