Gaggenau VI492115, Руководство пользователя и инструкции по установке

Страница: 38 / 44

en
Installation instructions
38
9.
To keep the power cord away from the drawer, use
the enclosed cable strap to secure the power cord
to the underside of the appliance.
If a longer power cord is required, please contact
customer service. Connecting cables up to 2.20 m
are available.
26.12 Installing the control knob
1.
If required, and depending on the distance between
the control knobs, break off the retaining plate at the
perforation.
2.
Hold the retaining plate in place against the rear of
the control panel.
3.
When fitting an individual control knob, use 2
screws to hold the retaining plate in place and pre-
vent it from rotating.
‒
In the case of stone worktops, stick the retaining
plate using heat-resistant, two-component adhes-
ive.
4.
Remove the protective film from the rear of the illu-
minated ring.
5.
Install the control knob in the correct sequence.
6. Push the control knob into the hole.
‒
Always position the side marking on the control
knob on the left.
7.
Ensure that the retaining lug on the retaining plate is
located on the upper side and the control knob is in
the zero setting.
8.
On the rear of the control knob, tighten the retaining
nut using the installation tool provided.
9.
Align the control knob precisely in the zero setting.