Gaggenau VI462105, Руководство пользователя и инструкции по установке

Страница: 38 / 44

en
Installation instructions
38
3.
When fitting an individual control knob, use 2
screws to hold the retaining plate in place and pre-
vent it from rotating.
‒
In the case of stone worktops, stick the retaining
plate using heat-resistant, two-component adhes-
ive.
4.
Remove the protective film from the rear of the illu-
minated ring.
5.
Install the control knob in the correct sequence.
6.
Push the control knob into the hole.
‒
Always position the side marking on the control
knob on the left.
7.
Ensure that the retaining lug on the retaining plate is
located on the upper side and the control knob is in
the zero setting.
8. On the rear of the control knob, tighten the retaining
nut using the installation tool provided.
9. Align the control knob precisely in the zero setting.
26.13 Connecting the control knob to the
connection cables
1.
Connect all of the control knobs to the enclosed
connection cables.
The two connectors on the control knob are
identical.
2.
Ensure that the plugs snap into place in the con-
nectors.
3.
Connect the central control knobs to one of the
longer connection cables.
4.
After installation, check that all of the plug connec-
tions are seated correctly.
5.
To secure all connection cables after installation,
bend the mounting brackets on the retaining plates.