Gaggenau VI 422 10, Инструкция по эксплуатации

Страница: 28 / 36

28
en
Cookware test
Establishing a direct connection
Make sure that the extractor hood is switched on and is
in search mode. Search mode means that the
connection process on the extractor hood has been
started.
Refer to your extractor hood's user manual for more
information.
1 Open the Home Connect settings menu.
~
"Opening or closing the Home Connect
settings menu" on page 22
2 Turn the control knob clockwise to position 2 .
After around 5 seconds, the illuminated ring around
the control knob flashes blue and yellow alternately.
••’
is displayed on the control panel. The hob is
connected to the extractor hood once the
illuminated ring on the control knob permanently
lights up green.
3 Close the Home Connect settings menu.
~
"Opening or closing the Home Connect
settings menu" on page 22
The illuminated ring on the control knob goes out.
Direct connection unsuccessful
If, after around 30 seconds, a connection could not be
established, the illuminated ring around the control
knob lights up red. Turn the control knob to another
position and then back to position
2 .
The illuminated ring on the control knob lights up blue.
After around 5
seconds, the illuminated ring around the
control knob flashes blue and yellow. The appliance is
trying to establish a connection again.
Connecting another hob to the extractor hood
In order to connect another hob to the extractor hood,
run through the direct connection again with the second
hob.
Controlling the extractor hood via the
hob
In the Home Connect app, you can adjust the behaviour
of your extractor hood depending on whether the hob or
individual cooking zones are switched on or off.
t
Cookware test
Cookware test
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1 Fill the pan with approximately 200 ml water and
place it at room temperature in the middle of the
hotplate that most closely matches the diameter of
the pan base.
2 Go to the basic settings and select the
™„
setting.
‹””
will be lit.
3 Touch the
@
or
A
symbol.
‹¯
will be lit. A signal
tone will sound and the hotplate indicators will be
lit.
The function has now been activated.
¥—¯
will be lit. After a few seconds, the hotplate
displays will show the results for the quality and speed
of the cooking process.
Check the result using the following table:
To activate the function again, select the
@
or
A
symbol.
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.