Gaggenau VG 414 210 CA, Руководство по установке

Страница: 11 / 44

11
2 Evenly insert the unit in the cut-out. Press the unit
firmly into the cut-out from above.
Note: The unit must sit firmly in the cut-out and
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.
3 Turn the control knob and the gas valve to the
zero position. Assemble the spindle between the
control knob and the gas valve. Slide the rear part
fully over the gas valve shaft. Fix the spindle in
place with the locking screw.
4 Connect the appliance to the mains and gas and
check that it is working. If the appliance switches
off, there may be air in the gas pipe. turn the
control knob to 0 and ignite again. Repeat the
operation until the appliance ignites.
5 Flush installation only: it is imperative to test
functioning before jointing!
Joint the surrounding
gap with a suitable, temperature-resistant silicone
adhesive (such as OTTOSEAL
® S 70). Smoothen
the seal joint with smoothing agent recommended
by the manufacturer. Observe the notes on
processing the silicone adhesive. Do not operate
the appliance until the silicone adhesive has dried
completely (at least 24 hours, depending on room
temperature).
NOTICE:
Unsuitable silicone adhesive used on
natural stone worktops will cause permanent
discoloration.
Connect Gas Supply
The appliance is shipped from the factory for use with
natural gas. It must be converted for use with propane.
A qualified technician or installer must do the
conversion.
Before connecting the appliance, please check
whether the local connection conditions such as gas
type and gas pressure match the appliance settings.
Make sure the gas supply is turned off at the manual
shut-off valve before connecting the appliance.
The gas connection must be in a location that permits
access to the manual shut-off valve and which, if
applicable, is visible after opening the door of the
cabinet.
SERVICER INFO ONLY
Connect the gas supply using the ½" U.S.A. elbow
and the fiber gasket supplied with the unit. The
shorter, nontapered thread fits into the threaded nut
on the hob. The longer, tapered U.S.A. thread is for
the incoming gas supply. Vent the gas line, check for
leaks. The gas pressure regulator is supplied with the
unit and comes set for natural gas. To convert
regulator to LP (propane) gas:
Make-Maxitrol Model RV 47 CL ½ PSIG
1 Remove the aluminum cap from the top of the
regulator.
2 Remove the yellow plastic shaft from the cap by
pushing it sideways until it pops out of the groove
in the cap.
3 Turn the shaft over and push back into the cutout
in the cap.
4 Replace the cap on the regulator.
D
E
F