Gaggenau VG 233 234 CN, Инструкция по эксплуатации

Страница: 19 / 24

19
Burnt-in residues
To remove stubborn, burnt-in residues you can
order the grill cleaning gel (order number 463582)
from your specialist retailer or from our after-sales
service. You can use it to clean the pan supports,
the burner parts and the stainless steel cooktop
base. If necessary apply the gel and leave
overnight. Please observe the manufacturer’s
instructions.
Do not use these cleaners
●
scouring or chemically aggressive cleaners
●
cleaners containing acid (e.g. vinegar, citric
acid, etc)
●
cleaners containing chloride or with a high
content of alcohol
●
oven cleaner
●
hard and scratchy sponges, brushes or
scouring pads
●
carefully rinse new sponge clothes before the
first use
Trouble shooting
Malfunctions often have simple explanations.
Please read the following notes before calling the
after-sales service.
Control panel Clean with a soft, moist cloth and
some soapy water; do not use too
much water. Dry with a soft cloth.
Immediately remove residues of food
containing acid from the control panel
(e. g. vinegar, ketchup, mustard,
marinade).
You can order a suitable care product
for the control panel (order number
311135) from your specialist retailer
or online. Apply the care product
evenly with a soft cloth on the control
panel after cleaning.
Control knobs Clean with a soft, moist cloth and
some soapy water; do not use too
much water.
Caution! Damage to the appliance:
Do not pull off the control knobs to
clean them.
Part/surface Recommended cleaning method
Fault Possible cause Solution
Malfunction of the
general electrical
system. The household fuse has tripped. Check the fuse box if the fuse has tripped.
The electric ignition
does not work. There may be food or cleaning products
stuck between the ignition sparkers and the
burners. The space between the ignition sparker and
the burner must be clean.
The burners are wet. Dry the burner caps carefully.
The burner caps are not correctly
positioned. Check that the burner caps are correctly
positioned.
Power cut Ignite the burner with a lighter or a match.
The burner flame is
not uniform. The burner components are not correctly
positioned. Ensure the components are correctly
positioned.
The grooves on the burner are dirty. Clean the grooves on the burner.
The gas flow is not
normal or there is no
gas. The gas supply is blocked via gas taps. Open all gas taps.
If the gas is supplied from a gas cylinder,
check that this is not empty. Change the gas cylinder.
The kitchen smells of
gas. There may be a leak in the gas cylinder
coupling. Check that the coupling is sound.
The burner goes off
after ignition. The control knob was not held down for long
enough. Once the burner is on, hold the control knob
down a few seconds longer. Fully press
control knob.
The grooves on the burner are dirty. Clean the grooves on the burner.