Gaggenau DI260110CN, Инструкция по эксплуатации

Страница: 37 / 44

Fault, what to do?
en
37
Removable streaks on glasses,
glasses with metallic
appearance and cutlery. Too much rinse aid. Set rinse aid amount to lower setting.
No rinse aid added or setting too low. Add rinse aid and check dosage
(recommended setting 4–5).
Detergent residue in the final rinse
programme section. Detergent
dispenser cover blocked by utensils
(cover does not open fully). Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance
dispenser in the tablet collecting tray.
Utensils precleaned too intensely;
sensors therefore decide on weak
programme sequence. Stubborn
soiling cannot be completely
removed. Do not prerinse utensils. Remove only large
food remnants.
Increase sensitivity of the sensors.
~
"Sensor setting" on page 27
Recommended programme Eco 50°
Initial or existing, irreversible
clouding of glass. Glasses not dishwasher-proof, only
suitable for dishwasher. Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to the
water hardness (if required one setting
lower).
Use detergent with glass protection
component.
Rust spots on the cutlery. Cutlery not adequately rust-resistant.
Knife blades are frequently more
severely affected. Use corrosion-resistant cutlery.
Cutlery will also rust if rusting parts
are rinsed at the same time (pan
handles, damaged utensil baskets,
etc.). Do not wash rusting parts.
Salt content in the rinsing water too
high, as salt dispenser lock not
fastened firmly or salt was spilled
while being refilled. Fasten salt dispenser lock firmly or remove
spilled salt.
Appliance cannot be switched
on or operated. Malfunction. Disconnect appliance from the power
supply; pull out the mains plug or switch off
the fuse. Wait at least 5 seconds, then
connect the appliance to the power supply.
Appliance does not start. The mains fuse has tripped. Check mains fuse.
Power cord not inserted. Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
The appliance door has not been shut
properly. Close the door.
Programme starts automatically. You did not wait until programme
ended. Perform reset.
The door is difficult to open. Child lock is activated. Deactivate the child lock.
Door cannot be closed. Door lock has been activated. Close door with increased force.
Door cannot be closed due to
installation. Check appliance installation: Door
or attached parts must close without
obstruction.
Cover on the detergent
dispenser cannot be closed. Detergent dispenser or cover guide
blocked by sticky detergent residue. Remove detergent residue.
Detergent residue in the
detergent dispenser
9*
or in
the tablet collecting tray
1B
.
Spray arms blocked by utensils,
therefore detergent is not rinsed out. Ensure that the spray arms can rotate freely.
The detergent dispenser was damp
when filled. Pour detergent into the dry detergent
dispenser only.
Fault Cause Remedial action