Gaggenau DI260110CN, Инструкция по эксплуатации

Страница: 32 / 44

en
Fault, what to do?
32
Fault, what to do?
Fault, what to do?
Experience has shown that you can rectify most faults
which occur in daily operation yourself. This ensures
that the appliance is quickly available to you again. In
the following overview you can find possible causes of
malfunctions and helpful information for rectifying them.
Note: If the appliance stops during dishwashing or does
not start for no obvious reason, first run the Abort
programme function (Reset) .
:
Warning – Improper repairs or use of non-original
spare parts may cause considerable damage and put
the user at considerable risk!
Always have repairs carried out by technicians. If a
component has to be replaced, always use original
spare parts.
Error message
Some faults are indicated at the top of the display
window
@
and on the front display *
):
and possible
remedies are offered (for example Filter system soiled
(E22) -->Clean filters).
* depending on the features of your dishwasher
Waste water pump
Large food remnants or foreign objects which were not
captured by the filters may block the waste water pump.
The rinsing water will then be above the filter.
:
Warning – Danger of cutting!
Sharp and pointed objects or glass fragments may block
the waste water pump.
Always carefully remove foreign objects.
Clean the waste water pump as follows:
1.
Disconnect the dishwasher from the power supply.
2.
Take out top basket
12
and bottom basket
1j
.
3.
Remove the filters
1Z
.
4.
Scoop out water, use a sponge if required.
5.
Prise off the pump cover (as shown) using a spoon.
Grip the pump cover by the crosspiece and lift
diagonally inwards (1). Remove cover completely.
6.
Check impeller wheel and remove any foreign
objects.
7.
Place pump cover in the original position (2) and
press down until it engages (3).
8.
Install filters.
9.
Re-insert baskets.
&/,&.