Gaggenau DI 461-131, Руководство по эксплуатации

Страница: 17 / 24

17
Waste water pump
Large food remnants in the rinsing water not retained
by the filters may block the waste water pump. The
rinsing water is then not pumped out and covers the
filter. In this case:
First disconnect the appliance from the power
supply.
Remove the filters
29
.
Scoop out water, use a sponge if required.
Using a spoon, prise off pump cover (as illustrated)
until it clicks, then grip the cover by the lug and first
pull it upwards until it resists and then pull it out
forwards.
Check inner compartment and remove any foreign
objects.
Place cover in the original position, press down and
engage.
Install filters.
Troubleshooting
Experience has shown that you can rectify most faults
which occur in daily operation without calling customer
service. Obviously this will save on costs and ensure
that the machine is quickly available again. The
following overview should help you locate the causes of
faults which may occur.
Warning
If an error code (E:01 to E:30) is indicated on the
digital display
3
, always disconnect the appliance
from the power supply and then turn off the tap.
You can rectify certain faults yourself (see following
fault description), for all other faults please contact
customer service and state the indicated fault E:XX.
Warning
Remember: Repairs may be carried out by technicians
only. If a component has to be replaced, ensure that
only original spare parts are used. Improper repairs or
use of non-original spare parts may cause considerable
damage and put the user at considerable risk.
... when the appliance is switched on
The appliance does not start.
The mains fuse has tripped.
The appliance plug has not been inserted.
The appliance door has not been shut properly.
... on the appliance
Lower spray arm rotates sluggishly.
Spray arm blocked.
The door is difficult to open. *
Child-proof lock is activated. The deactivation
instructions are at the back in the envelope.
* depending on model
Door cannot be closed.
Door lock has been activated. To reset, close
the door with greater force.
... changing settings
A setting cannot be changed, a programme
starts.
Wrong programme button pressed.
Terminate the programme (see chapter entitled
“Terminating the programme (Reset)”) and start
all over again.
You did not wait until programme ended.
Cover on the detergent dispenser cannot be
closed.
Detergent dispenser overfilled or mechanism
blocked by sticky detergent residue.
Detergent residue in the detergent dispenser.
Dispenser was damp when filled.