Gaggenau DF461, Руководство по эксплуатации

Страница: 5 / 23

5
Getting to know your appliance
Diagrams of the control panel and the interior of the
appliance can be found in the envelope at the front.
Individual positions are referred to in the text.
Control panel
1
Main switch
2
Door opener
3
Time delay
4
Digital display/
Programme progress indicator
5
Salt refill indicator
6
Rinse-aid refill indicator
7
Programme buttons
8
Additional functions *
* some models only
Appliance interior
20
Upper basket with 2-tiered cup rack
21
Additional cutlery basket for the top basket *
22
Upper spray arm
23
Lower spray arm
24
Container for special salt with level indicator *
25
Filters
26
Cutlery basket
27
Lower basket
28
Lock for detergent dispenser
29
Container for rinse-aid, with level indicator
30
Detergent compartment
31
Nameplate
* not on all models
You will need to purchase the
following before using the dishwasher
for the first time:
– special salt for use in dishwashers
– detergent
– rinse-aid
Only use products, which are suitable for dishwashers.
Water softener
In order to rinse dishes and glasses satisfactorily, the
dishwasher requires soft water, i.e. containing little or
no lime, otherwise water stains will be left behind on
crockery and glasses, etc.
If the tap water exceeds a certain level of hardness, it
must be softened, i.e. decalcified, so that it can be
used in the dishwasher.
This is achieved by adding a special salt to the water
softener inside the dishwasher.
The water softener, that is the required amount of salt,
is set up according to how hard the tap water is.
Setting up the water softener
Determine the level of hardness of your tap water.
Your local water company or service agent can help
you with this.
Identify setting from the following water hardness
table.
Water hardness table
Hold down programme button
B
and switch on the
1
main switch, then release both buttons.
The LED for button
B
flashes and the digital
display displays the factory setting .
To change the setting,
press programme button
B
.
Each time the button is pressed, the set value
increases by 1; after
, the setting goes back to
.
Switch off the main switch
1
. The chosen setting
has now been stored.
Approx. 4 litres of water are required for regenerating
the water softening system. The overall water
consumption per load can therefore be increased by
between 0 and a maximum of 4 litres according to the
water hardness setting.